LOC Precision Flying Model Rocket Kit 2.26" LASERLOC 223 LOC LL223
The LaserLOC series was one of the first production minimum diameter MID-HIGH POWER kits available to the public. Keeping the tradition going we have a few modern day tweaks that will put your skills to the test. A gentle laser etch around the slots allow for easier glassine removal. Multi-slot airframe allow the fins to click into the booster. Precut 4oz fiberglass cloth can be easily epoxied from fin-airframe-fin. This reinforcement will give your LaserLOC the strength for today’s higher impulse motors. Fiberglass should be applied with a long cure epoxy for best results. If you have never glassed anything before, here’s your chance! 1/4″ Launch lugs included. Fly away rail guides are another alternative. Full dual deployment ready with electronics bay and recovery included. Go ahead, drag race your fiberglass friends!!!
Strong enough for supersonic flights. Light enough on your wallet and to fly an F motor!!!
Finishing
Using a high build primer apply 2-3 coats. sand with 400 until spirals are filled. Paint as desired or follow below.
Createx Paint. Follow manufacturers recommendations for applications
To achieve OEM color(s) the following paint was used and their respective ratios
6002 Sealer Black
4258 Gloss Black
4004 Quick Silver. 1 lite coat, 2 moderate coats (do not over coat!)
4030/4657 3:1 Balancing Clear and Caribe Blue (until desired density)
lightly sand with 1000 grit to knock down any overspray before applying decals. Clear as desired after decal application.
Polyethylene Enhanced Nose Cone
Nylon Parachute Recovery
Payload Section with Electronics Bay
2.2" Slotted Airframe
54mm Motor Mount
Laser Cut Rings and Fins
Rail Guides and Launch Lug
Vinyl Decal
Assembly Required Expert Level Complexity Skill Level Pro
Made in the USA
Full Dual Deployment Ready
Diameter: 2.2″
Height: 58.5
Weight: 28 oz.
Motor Mount: 54mm minimum diameter – MMA-4 38mm included
Parachute Size: 28″ Ripstop Nylon with 12″ Drogue
Shock Cord Type: 2x TN-316-15 15′ 3/16″ Tubular Nylon with sewn loops
Shock Cord Mount: Snuffer Tube – 38mm motor tube + 2 centering rings
Fin Thickness: 1/8″
Ring Thickness: Minimum Diameter
Starter Recovery Blankets x2
Vinyl Decals
Instructions
LaserLOC223 Rocksim
Motors:
F-25-7 750.
G61-10 1300'
H73-13 2400'
I-115-16 5200'
If you are just starting in the hobby start at the beginner level and move up from there at your own pace.
What is needed to build and fly
All model rockets come in kit form that require assembly. The materials are primarily cardboard tubes, balsa or plastic fins and nose cone. Materials will vary by model and are typically specified in the description of each kit.
Additional supplies will be necessary to build and finish your model rocket kit and may include:
Scissors, Hobby Knife
Ruler
Wood Glue, Model Cement or CA(Super Glue)
Sandpaper
Masking Tape
Finishing Supplies like:
Wood Filler
Sealer/Primer
Paint
Launching Equipment and Supplies like:
Recovery wadding
Launch Pad
Launch Controller
Power supply
Model Rocket Motors and Igniters
A safe place to fly using guidelines from the National Association of Rocketry Safety Code
